钢丝绳输送带的两种修复方法。
Two repair methods for steel wire rope conveyor belts.
钢丝绳输送带的修复方法有几种，所以输送带厂家小编将简要介绍前两种方法：
There are several methods for repairing steel wire rope conveyor belts, so the editor of the conveyor belt manufacturer will briefly introduce the first two methods:
1.局部橡胶硫化法:用小硫化器硫化局部损坏。由于硫化器尺寸的限制，修复速度只有0.5m/h左右。这种方法不适合长距离修复。
1. Local rubber vulcanization method: Use a small vulcanizer to vulcanize local damage. Due to the size limitation of the vulcanizer, the repair speed is only about 0.5m/h. This method is not suitable for long-distance repairs.
2.橡胶粘贴方法：采用德国技术的橡胶粘贴方法，其最大优点是修复速度快。打磨清洗后，涂上粘合剂，粘贴橡胶，即可启动操作。缺点是：通常在60-90d后，橡胶会脱落。更大的问型槽模具 一次性止血带 保定水处理设备 一次性止血带 保定空压机 北京真空泵题是，如果环形输送带在潮湿的环境中运行，水蒸气就会积聚在粘合面的间隙中，腐蚀钢丝绳。钢丝绳会随着时间的推移而生锈。甚至会导致整个输送带突然断裂。此外，这种修复方法的成本也很高。
2. Rubber pasting method: Adopting German technology for rubber pasting, its biggest advantage is fast repair speed. After polishing and cleaning, apply adhesive and stick rubber to start the operation. The disadvantage is that the rubber usually falls off after 60-90 days. The bigger problem is that if the circular conveyor belt operates in a humid environment, water vapor will accumulate in the gaps between the bonding surfaces and corrode the steel wire rope. Steel wire ropes will rust over time. It may even cause the entire conveyor belt to suddenly break. In addition, the cost of this repair method is also high.
输送带厂家简要介绍了波状挡边输送带的六大特点。
The conveyor belt manufacturer briefly introduced the six characteristics of corrugated edge conveyor belts.
日常生活中看到的输送带种类繁多，如普通输送带、尼龙输送带、环形输送带等产品种类繁多，其中挡边输送带是大倾角波形挡边输送带，其组成部分由基带、挡边成。波形挡边输送带的特点如下:
There are various types of conveyor belts seen in daily life, such as ordinary conveyor belts, nylon conveyor belts, circular conveyor belts, and other products. Among them, the edge conveyor belt is a large angle waveform edge conveyor belt, which is composed of a base belt and a edge guard. The characteristics of the corrugated edge conveyor belt are as follows:
一、能耗低，结构简单，胶带强度高，使用寿命长；
1、 Low energy consumption, simple structure, high tape strength, and long service life;
二、适用于输送易散落的粉状、粒状、小块状、糊状和液体材料；
2、 Suitable for conveying powder, granular, small, paste, and liquid materials that are prone to scattering;
三、从水平到倾斜（或垂直）能平稳过渡；
3、 Smooth transition from horizontal to inclined (or vertical);
四、输送量大。提升高度较高；
4、 Large conveying capacity. Higher lifting height;